Check out this Good Looking, Super Tough, Aftermarket Molded Snorkel Kit for your Nissan D23 Navara and turn your Navara NP300 into a "Tough Truck"
This Aftermarket Snorkel kit will fit all the Nissan D23 Navara NP300 2015 model onwards and is compatible with the Nissan YD25 - DDTi 2.5 ltr Diesel motor
Installing a Snorkel on your 4WD will raise the air intake and improve overall performance as well as protecting your engine from dirt and water damage
These are made from indestructible, flexible, Roto Molded Polyethylene (LLDPE) that will stand up to the toughest of conditions without breaking
A snorkel relocates your engines air intake point from a relatively low and vulnerable position under the bonnet to a much higher and safer location where a constant source of cool, clean air is available.
And because a snorkel is forced through the air as the vehicle travels, it creates what is known as ram air effect. This has often been found to provide a welcome increase in engine performance.
Comes in a durable, textured semi gloss black finish that will not scratch off and is also UV Resistant
The Full Kit comes with Templates and all hardware, (Screws, Pins, Cerclips and Washers) for a left hand side fit
Fitting instructions are provided on line by Google, but if you are not familiar with fitting a Snorkel, it is advised that you get it professionally installed
Kut Snake NZ are the New Zealand Agents for Kut Snake "Tough Truck" molded wheel arch Flare Kits and Accessories